B hyd pump questions
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=29744
Printed Date: 04 Mar 2025 at 7:15pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: B hyd pump questions
Posted By: hermin's dad
Subject: B hyd pump questions
Date Posted: 25 Apr 2011 at 4:22pm
|
where is resevoir for hyd on b, controls? have tractor with delete plate wondering about all this. Anyone have one for sale resonable?
|
Replies:
Posted By: Tedin NE-OH
Date Posted: 25 Apr 2011 at 4:26pm
|
The reservoir is the transmission housing, so you have one. You need the pump ans connections. Call Sandy Lake Implement. They have rebuilt pumps 1-888-252-0656
|
Posted By: Tedin NE-OH
Date Posted: 25 Apr 2011 at 4:29pm
|
Make sure you change tranny fluid to Universal Hyd/ Transmission fluid. It is what is needed for good operation.
|
Posted By: hermin's dad
Date Posted: 26 Apr 2011 at 5:45pm
|
what about controls are they located on the pump,are there tubes going down into the trans housing?
|
Posted By: hermin's dad
Date Posted: 27 Apr 2011 at 11:57pm
Posted By: CTuckerNWIL
Date Posted: 28 Apr 2011 at 6:23am
The pump runs off the PTO shaft so your PTO has to be engaged for it to work. The only other control is the valve which is on the pump. There is one pick up tube that hangs off the pump.
-------------
http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF
|
Posted By: hermin's dad
Date Posted: 28 Apr 2011 at 4:28pm
|
Purchased pump off ebay. How long is pickup tube for pump?also are gaskets avail for pump and pto if pto has to be removed?
|
Posted By: CTuckerNWIL
Date Posted: 28 Apr 2011 at 5:19pm
The pick up tube is not very long. It comes out of the pump and turns down 90 degrees. probably not more than a 1/2 inch below the pump. Gaskets can be made very easily. Lay gasket material over the side of the pump and tap around the edges and holes with the ball end of a ball peen hammer.
-------------
http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF
|
Posted By: CTuckerNWIL
Date Posted: 28 Apr 2011 at 5:27pm
If you have the delete plat, all you should have to do is remove it and bolt the pump on. Hook up lines to your cylinders, pour in some fluid and you're ready. You might want to stick the pickup tube in some oil and manually pump it to prime it before assembly.
-------------
http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF
|
|