Farm Equipment - 2000 Plow

Print Page | Close Window

2000 Plow

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=29595
Printed Date: 04 Mar 2025 at 11:17am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 2000 Plow

Posted By: DOlson
Subject: 2000 Plow
Date Posted: 22 Apr 2011 at 11:42pm

How bad of a job is it to replace the pivot pin bushings on the re-set stub beam on a hydraulic re-set plow and how much play is excitable?

Thank Derrick

Replies:

Posted By: Jim Hancock
Date Posted: 22 Apr 2011 at 11:48pm

Don't know. We never did that I remember. Maybe we just didn't need to, otherwise I would've been in the middle of it helping dad.

Posted By: JimWenigOH
Date Posted: 23 Apr 2011 at 6:28am

I needed some parts from one from a salvage yard one time. After beating on it with a big hammer for a while, the fellow gave up and I bought the complete assembly to keep the part I needed from getting damaged. I have a press I plan to use when I get around to it. In the mean time I occasionally squirt penetrating oil on the joints to soften things up.

Posted By: 427435
Date Posted: 23 Apr 2011 at 10:15am

You will need a big wrench to get the nuts loose and properly tight again. I remember buying a 600 ft-lb torque wrench (but not the actual torque setting) when I was testing these trips.

-------------
Mark

B10 Allis, 917 Allis, 7116 Simplicity, 7790 Simplicity Diesel,
GTH-L Simplicity

Ignorance is curable-----stupidity is not.

Posted By: DOlson
Date Posted: 23 Apr 2011 at 6:59pm

I have the tools just need to know is more work than its worth, plow has a lot of good parts. Or should I just use it tell its wore out

Posted By: DOlson
Date Posted: 24 Apr 2011 at 9:35pm

bump