WD narrow front end
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=29018
Printed Date: 03 Mar 2025 at 4:09pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: WD narrow front end
Posted By: Josh Day
Subject: WD narrow front end
Date Posted: 12 Apr 2011 at 6:29pm
| I have a 53' WD and I am going to put new bearings and seals in my narrow front. I was wondering what size of gear poller to use to get the worm gear off of the top of shaft or is there a better way to do this? thanks Josh Day |
Replies:
Posted By: CTuckerNWIL
Date Posted: 12 Apr 2011 at 8:30pm
|
I think I put my WC shaft in a press at work and pushed it out. I had to make a new shaft for mine.
------------- http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF |
Posted By: Pa.Pete
Date Posted: 13 Apr 2011 at 10:25am
| There is a bolt on the bottom of the spindle housing that you remove then you can pull the gear and shaft straight up and out. |
Posted By: CTuckerNWIL
Date Posted: 13 Apr 2011 at 10:42am
|
For some reason I had the input steering shaft in mind. ------------- http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF |
Posted By: Pa.Pete
Date Posted: 13 Apr 2011 at 10:56am
Probably because he said he wanted to get the worm gear out, but since he was wanting to replace the seals I figuired he was talking about the verticle shaft.
|
CTuckerNWIL wrote: