Farm Equipment - engine change out will it work

Print Page | Close Window

engine change out will it work

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=28226
Printed Date: 01 Mar 2025 at 1:32am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: engine change out will it work

Posted By: dudley wallace
Subject: engine change out will it work
Date Posted: 30 Mar 2011 at 1:16pm

i have an engine out of a e gleaner combine what tractor will it fit and what will i have to change i have a wd45 with a bad engine thanks for your help dudley.

-------------
a member of hendricks county antique tractor and machinery association club.

Replies:

Posted By: skipwelte
Date Posted: 30 Mar 2011 at 2:26pm

yes it will, youll need the govenor, water pump, front pulley off the WD45 eng. You have to space the water pump pulley out about 1/2 inch to line up with the crank pulley as the crank snout on the gleaner eng is longer.

Posted By: myallis
Date Posted: 30 Mar 2011 at 3:54pm

Remove fuel pump and make a cover for it this is where the steering shaft goes through. The crank pulley you can do as the other guy said and space the water pump or you can bore the center of crank pulley and shove it on to line up with the water pump or just cut the end of the shaft off and slide the pulley on. If you do this you will have to drill a small indent to hold the set screw on pulley to crank shaft. The governor you can either pull the front cover off the 45 engine on put on gleaner engine this will require boring i think 2 holes bigger on the cover because of bigger bolts in gleaner engine or use the gleaner cover an put the throttle shaft in where the soft plug is this usually with have to have a bushing to make it tight in the hole. Steel line for oil need to be turned/tweeked a bit to clear the steering shaft or I replace with knew compression fittings and flexible oil resistant air brake line. The governor weights in the combine engine come to a point not ramped like tractor engines so I switch these out also. I think I covered it all.

Posted By: cougar766
Date Posted: 30 Mar 2011 at 5:29pm

gee wiz brother I see how I rate you don't even let me in on this, I'll remember you

Posted By: myallis
Date Posted: 30 Mar 2011 at 10:02pm

? I'm sorry was just trying to give a guy a helping hand and options didn't meen to offend anyone. I love this site.

Posted By: AdamA
Date Posted: 30 Mar 2011 at 10:16pm

Not sure but I think cougar766 was making a sarcastic reply too dudley's post, looks like they are both from the same town?

-------------
57'D-17,78'185,83'6080,76'7040,84'8030 FWA.02'Dodge cummins

Posted By: cougar766
Date Posted: 31 Mar 2011 at 7:53am

I was harassing Dudley, we normally get into these thing together, sorry didn't mean to upset anybody

Posted By: myallis
Date Posted: 31 Mar 2011 at 8:10am

haha. Thats good . None taken. I didn't want to either