Farm Equipment - Agco Allis 9435 PTO Help!

Print Page | Close Window

Agco Allis 9435 PTO Help!

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=28174
Printed Date: 28 Feb 2025 at 10:26pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Agco Allis 9435 PTO Help!

Posted By: cjfleenor
Subject: Agco Allis 9435 PTO Help!
Date Posted: 29 Mar 2011 at 5:55pm

I have a 1995 Agco Allis 9435 that is new to me. I needed to remove the 540 PTO shaft today, and wanted to put the 1000 rpm shaft in. The 540 came out with quite a bit of difficulty, but I couldn't get it back into the tractor either. A come-a-long later, the 540 shaft popped out. After trying everything, I can now only get the 540 or the 1000 shaft back in up to approximately 1/4 to 1/2 of an inch. The end of the large area of the shaft is literally 1/4 of an inch away from sliding in and allowing me to place the retaining clip back in place. I've talked the local dealers...several times, and short of them looking at it they are clueless. I think the issue could be the roller bearings in the front end of the housing, but I'm not sure. Any suggestions? I worked on it for 7 hours today...and still no success. I'm open for thoughts/stories on how to fix this...or a cost for the dealer to fix it if it is that bad. *Note* I have the splines lined up, etc, as the obvious thoughts would suggest...am I missing a trick here?

Thanks

C.J. Fleenor

Southern Indiana Allis User

Replies:

Posted By: Russ SCPA
Date Posted: 29 Mar 2011 at 7:08pm

Not sure but does it have the Oliver/White "tail feathers"? If so there is a set screw on side of pto housing that needs to be loosened to exchange shafts. It has been a long time since I played with the tail end of a White so memory could well be wrong.

Posted By: DrAllis
Date Posted: 29 Mar 2011 at 7:32pm

9435/9455's are a Massey rearend.