wd45 pulling hitch
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=26770
Printed Date: 27 Feb 2025 at 1:15am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: wd45 pulling hitch
Posted By: bubschooley
Subject: wd45 pulling hitch
Date Posted: 05 Mar 2011 at 11:45am
|
Looking for some ideas on a adjusting pulling hitch for a wd45 tractor. thanks |
Replies:
Posted By: ChuckLuedtkeSEWI
Date Posted: 05 Mar 2011 at 11:51am
|
How much are you trying to adjust it? What I did was remove the snap coupler bell and then I made a hitch that picked up the shaft that the bell pivoted on. On the back, I just used some longer bolts and some spacers to get the drawbar up or down, and used the other pivot brackets for the drawbar support to adjust the other way. I could have made a whole new drawbar support, but with our height and distance from rear axle center to hitch, it wasn't worth it. ------------- 1955 WD45 diesel 203322 was my dad's tractor, 1966 D15 23530, 1961 HD3 Crawler 1918, 1966 D17 IV 83495, 1937 WC 41255, 1962 D19 6221 |
Posted By: Allis Fields
Date Posted: 05 Mar 2011 at 6:38pm
Use a pin hitch front half drawbar. I had Phil Brown from Farley Ia. Build Mine He's within 50 miles from you . He can build A very good one . He goes bt d17brown on here.  ------------- Allis orange blooded by family. Allis Diehard by choice |
Posted By: HaroldOmaha
Date Posted: 05 Mar 2011 at 11:07pm
I just took a D series straight draw bar and cut it off short as legal. Put it in the standard yoke, and use washers to fine tune the height. It works great. 
|
Posted By: cwhit
Date Posted: 06 Mar 2011 at 7:51am
| X2, like Harold Omaha, ours looks just like his. Works great. |