5015 hyd. pproblem
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=25978
Printed Date: 10 Mar 2025 at 5:25am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 5015 hyd. pproblem
Posted By: bacon6
Subject: 5015 hyd. pproblem
Date Posted: 19 Feb 2011 at 4:57pm
| I just purchased an '83 allis chalmers 5015 tractor and am having problems with the hydrolics, the fluid looked contaminated w/water so I changed it & filter, espicialy when warmed up seems to strugle to lift, sometimes won't lift at all, I've heard of a possible internal filter that needs to be cleaned but no one knowes where it is, any help?? everything else working fine, trans. pto all good |
Replies:
Posted By: ALinIL
Date Posted: 19 Feb 2011 at 5:26pm
| Have you checked the fluid level. Also If water got into the system, the fluid is contaminated and will clog the filter again. There is only the single filter per the AGCO parts book. |
Posted By: bacon6
Date Posted: 19 Feb 2011 at 7:04pm
| that makes since when I changed the fluid I installed a small "oil filter" that matched up the to help clean up the system before installing the proper filter, everything worked fine at first but after acouple hours of run time stoped working again Thanks |
Posted By: GARY(OH/IN)
Date Posted: 20 Feb 2011 at 12:33am
| I'll jump on the back here with another 5015 hydralic question. The loader fades with or without weight in the bucket. The 3 point arms hold good though. Any suggestions? |
Posted By: mtanut
Date Posted: 20 Feb 2011 at 6:58am
I am going to guess you have two different issues. Your 3 point will have an internal valve for the 3 point, and your loader has a separate valve assembly. because it would tie in to the external ports on the tractor. I think you need to rebuild your loader valve. ------------- I have a 185 Allis, 6060 Allis, Model K gleaner, SMTA ferg 35, ferg 20 (paps first tractor, Allis B (wife's)John Deere 240 skid loader and a bunch of the usual farm stuff. |
GARY(OH/IN) wrote:Posted By: bacon6
Date Posted: 20 Feb 2011 at 6:53pm
| another question,is there any fluid I can use to flush the system other than regular 303 hyd. fluid, seams to be getting better as I change filters but feel a good flushing is in order Thanks |
Posted By: oldwelder
Date Posted: 29 May 2011 at 12:27pm
|
I had the same problem with the bucket drifting. I replaced the O rings in the cylinders.. You can pick them up at NAPA or order them on line. There is a nylon O ring in there also. I did not replace it Bucket is holding up fine for the last 1 1/2 years .I use my AC 5015 for just about everything ,,5 ' woods deck 3 point 4 ' tiller Hauling wood in the wither ,plowing the snow ,and digging up dirt I have a 1983 with about 1400 hours on it. |