Farm Equipment - Carb install on UC?

Print Page | Close Window

Carb install on UC?

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=25737
Printed Date: 25 Feb 2025 at 12:36pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Carb install on UC?

Posted By: ac_bowsers
Subject: Carb install on UC?
Date Posted: 14 Feb 2011 at 8:35am

Been a while since its been off, trying to finish up restore, I put carb on lined up notch, but all it does is idle, do you have to have spring pressure against governor shaft or did I simply not get notch into wood bushing. Probably a dumb mistake any help out there thanks!!!

-------------
Pine Stock Farm "Home of the ALLIS" 35-WC-36-U-37-UC-47-C-49-G-57-D17-58-D17puller-63-D21-71-210puller-79-7045-83-8070-AA9675-BigTen-B10-310-1300fieldcult-snapcoupler imp.-longhopper blower,signs,etc.

Replies:

Posted By: Fred in Pa
Date Posted: 14 Feb 2011 at 11:13am

Been in to alot of these just a U last week .Where do you see a wooden bushing .There is a felt that is around the shaft that comes thrught the block ,for oil control .

Posted By: ac_bowsers
Date Posted: 14 Feb 2011 at 11:32am

the piece inside carb where shaft from block goes into

-------------
Pine Stock Farm "Home of the ALLIS" 35-WC-36-U-37-UC-47-C-49-G-57-D17-58-D17puller-63-D21-71-210puller-79-7045-83-8070-AA9675-BigTen-B10-310-1300fieldcult-snapcoupler imp.-longhopper blower,signs,etc.

Posted By: Fred in Pa
Date Posted: 14 Feb 2011 at 12:46pm

Brass !!!!