Farm Equipment - 190 XT questions

Print Page | Close Window

190 XT questions

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=25419
Printed Date: 25 Feb 2025 at 3:02am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 190 XT questions

Posted By: Dwayne TX
Subject: 190 XT questions
Date Posted: 07 Feb 2011 at 11:42pm

First, how do you access the linkages for the throttle, hydraulics, etc? Is it the one panel in the center or does the front come off?

And, how big a project is it to replace the seals behind the lift arms on the splined shaft? It's developed a pretty good leak, so I need to fix it quick.

Replies:

Posted By: skipwelte
Date Posted: 08 Feb 2011 at 9:34am

There is a access panel on the inside of the console about where the seat is. Not a lot of room but thats all ya get. There is a snap ring on the outside of each lift arm, take off the snap ring, the arm slides on a splined shaft. After the arm is off slide the shaft thru the housing a ways to get to the oring oil seal. If your bushings are worn replaceing orings probably wont fix it. Also check to make sure the oil level isnt to high in the rear end. Good luck.

Posted By: AndrewGubbels
Date Posted: 08 Feb 2011 at 7:15pm

skip you are dead on!! it is just not an easy task.

andrew

-------------
Andrew Gubbels
Gubbels Restoration