Farm Equipment - D17 hub

Print Page | Close Window

D17 hub

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=24740
Printed Date: 24 Feb 2025 at 6:28am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: D17 hub

Posted By: D17 owner
Subject: D17 hub
Date Posted: 26 Jan 2011 at 8:28pm

I agian, I have the D17 in the shop been taking it apart to see what is banging (anther post) And way I was looking in the service book it says to remove the hud take dust cap off remove bolt and bottom pan remove snap rin between bull gear and housing and push or pull out. I did all of that, but not the "just push out part"! It will not move I even used I BIG bar nothing. What am I doing wrong? I need to get this out to replace the seal. Thanks Eric

Replies:

Posted By: mattb
Date Posted: 27 Jan 2011 at 9:28am

sometimes the bearings are froze onto the shaft. use a big hammer orr a hyd jack to push shaft out