WC oil pump gasket?
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=24681
Printed Date: 24 Feb 2025 at 3:02am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: WC oil pump gasket?
Posted By: Thad in AR.
Subject: WC oil pump gasket?
Date Posted: 25 Jan 2011 at 7:45pm
|
I'm wondering if an oil pump gasket comes with an overhaul set? I took the plate off and cleaned the oil pump and I want the right thickness gasket. I have to buy a complete gasket set anyway. Also will it have manifold gaskets?
|
Replies:
Posted By: Denis in MI
Date Posted: 25 Jan 2011 at 8:11pm
my felpro complete set came with one
-------------
1938 B, 1945 B, 1941 IB, 1949 C, 2 1938 WCs, 3 1950 WDs, 1951 WD, 2 1955 WD45, 1957 D-14
|
Posted By: Butch(OH)
Date Posted: 25 Jan 2011 at 8:25pm
|
Be carefull when replacing that gasket as the one in the kits is often waaaay to thick leaving you to wonder why you have little oil pressure. Actualy if the pump is worn at all the best thing is to eliminate the gasket. Stone the surfaces flat. Bolt it together to make sure it doesnt bind then take it apart and use just a very small amount of silicone sealer under the cover. Yes the manifold gaskets will be in a complete OH kit.
|
Posted By: Thad in AR.
Date Posted: 26 Jan 2011 at 4:04am
|
I put the plate back on after cleaning snugged the screws and it turns hard like it's dragging. Should I make one out of paper of some sort?
|
Posted By: Butch(OH)
Date Posted: 26 Jan 2011 at 5:41am
|
Realy? I have never run into one that unworn, well in the last 30 years anyway, LOL. First make sure you didn't flip the idler gear over, needs to go back the same way it came out and ck again. That not being the case it used to be available from AGCO as a seperate item. Ck there first. The paper should be so thin it is both delicate and translucent. The paper is available as sheet but making one wouldnt be fun times.
|
Posted By: Thad in AR.
Date Posted: 26 Jan 2011 at 6:09am
|
Thanks for the help Butch. I'll check with agco on the gasket. I'll also remove the idler and put the cap back on and see what happens. The idler just wanted to go on one way when I put it back together.
|
|