Farm Equipment - governor housing Allis B

Print Page | Close Window

governor housing Allis B

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=22499
Printed Date: 13 Feb 2025 at 11:41am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: governor housing Allis B

Posted By: Fred
Subject: governor housing Allis B
Date Posted: 18 Dec 2010 at 7:02pm

What is the best way to cure the oil leak around the post that the throttle linkeage and oil line hooks to.

The post is loose, I could pull it out. I tried Form a Gasket and it didn't seem to work. I was thinking of JB Weld however it's only a little bit loose, just loose enough to leak.

Any suggestions would be appreciated. Thanks

Replies:

Posted By: Fred
Date Posted: 20 Dec 2010 at 2:54pm

JB Weld did the trick. I took the post out and clean the hole and the post. I used a wax and grease remover and a q-tip in the hole. Just a thin coat of JB Weld on the spline on the post and tapped it back in. 24 hour cure... hooked everything up - No leak and now the post is nice and firm too.