Farm Equipment - 2-12 plow depth link

Print Page | Close Window

2-12 plow depth link

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=206878
Printed Date: 31 May 2025 at 5:54pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 2-12 plow depth link

Posted By: 560Dennis
Subject: 2-12 plow depth link
Date Posted: 28 May 2025 at 7:22pm

My model 4 has long rear landslide.

My question is about the link that goes from the axle lift to the depth control lever( left side in Tractor seat) .

I cannot lift the plow with lever to plow a 6 inch depth furrow. I’m going to deep. The lever is all the way down locked.

I was told that the model 2 has a link with three holes in it.

If you’re familiar with that plow could you please verify that.

I would also like to know the distance between each hole ? This would be a great help.

I measure mine and it was 17.5 inches approximately center of holes in link rectangle lift bar .

My manual sayes that the tires should be 5.00-16. ( 25.5 outside diameter) I currently have 4.6-16 motorcycles tires which are not quit 25 inches out side diameter.

Thanks for your comments

Replies:

Posted By: jiminnd
Date Posted: 28 May 2025 at 9:20pm

I think I have the same plow, will check tomorrow and measure.

I think that is what mine is, it measures 17 inches hole to hole, I have 6.00 16 tires off a WD on mine and it works fine.

-------------
1945 C, 1949 WF and WD, 1981 185, 1982 8030, unknown D14(nonrunner)