Print Page | Close Window

d17 loader

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=204970
Printed Date: 22 Jan 2025 at 5:34am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: d17 loader
Posted By: Bluetick58
Subject: d17 loader
Date Posted: 16 Jan 2025 at 2:19pm
is there anyway to keep 3 point up while dropping loader, blade on back drops as soon as loader on d17?



Replies:
Posted By: Nathan (SD)
Date Posted: 18 Jan 2025 at 7:26pm
I made a piece for a guy once that sat on the drawbar and went to the top link on the 3pt attachment to hold it up. Not convenient, but effective.


Posted By: tractorboy
Date Posted: 18 Jan 2025 at 7:49pm
I use a small chain attached to seat bracket to hold up the arms "no implement" .   My buddy plumbed a cut off valve mounted to the fender on his D15 ,bit I think that's to isolate the loader when he uses the 3point.  keith so va.


Posted By: Gary
Date Posted: 18 Jan 2025 at 9:03pm

The easiest way to have the most useful results is to install a Diverter Valve in the Steel Hydraulic Line that runs from the left side of the Torque Tube to the top of the L/H Rear Axle Housing.

Allis had an Optional Valve that mounted on top of the housing and connected to the threaded Port that feeds the Internal Lift Cylinder.

This was a Push / Pull Diverter Valve so you could feed either the Rear Lift OR the Loader.

The Loader normally connected to the rear of the Valve via a Quick Disconnect.

G


Posted By: Bluetick58
Date Posted: 19 Jan 2025 at 6:06am
Thanks guys



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net