D14 steering seal
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=204691
Printed Date: 25 Dec 2024 at 9:28pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: D14 steering seal
Posted By: AC720Man
Subject: D14 steering seal
Date Posted: 24 Dec 2024 at 10:43pm
Parts I need for my front support finally came in. The seal for the shaft retainer was a concern because it looked like a sweeper(felt)on top of a seal. The book only calls for 1 oil seal. As I described this to Brenda, she showed only 1 seal and it wasn’t nearly as thick as the original with no felt sweep built into it. Only seal available for it. Once the old one was driven out it is clear that it was all one seal and 2-3 times as thick as the new one. My concern is, this seal was driven down on a shoulder which made it flush with the retainer face. As it was designed. With the new one driven down on the shoulder it will be far below the retainer face. Should I order another seal and stack it on top of this one and drive it flush with the retainer face? My only other choice is to find a NOS seal from someone. Suggestions please
-------------
1968 B-208, 1976 720 (2 of them)Danco brush hog, single bottom plow,52" snow thrower, belly mower,rear tine tiller, rear blade, front blade, 57"sickle bar,1983 917 hydro, 1968 7hp sno-bee, 1968 190XTD
|
Replies:
Posted By: Mikez
Date Posted: 25 Dec 2024 at 12:29am
|
Are you referring to 229967 seal
|
Posted By: Gary(VA)
Date Posted: 25 Dec 2024 at 5:31am
|
Good Morning Robbie and Merry Christmas I can’t speak to the seal for the steering but I remember the same issue on the rear pto seal on a D14 or 17 and ended up doubling the seals and worked fine.
|
Posted By: Tom IA
Date Posted: 25 Dec 2024 at 7:49am
|
I always double up on the replacement seal have done 15 17 19 no problems
|
Posted By: jaybmiller
Date Posted: 25 Dec 2024 at 8:40am
|
Ii did the double seal trick for one rear axle... ..wished I'd both back then....sigh
-------------
3 D-14s,A-C forklift, B-112
Kubota BX23S lil' TOOT( The Other Orange Tractor)
Never burn your bridges, unless you can walk on water
|
Posted By: AC720Man
Date Posted: 25 Dec 2024 at 6:20pm
Yes Mike, with 70 in front of it on the AGCO site.
I will see if anyone has a NOS first in the next few days, if not I will double seal it. Thanks everyone for responding.
-------------
1968 B-208, 1976 720 (2 of them)Danco brush hog, single bottom plow,52" snow thrower, belly mower,rear tine tiller, rear blade, front blade, 57"sickle bar,1983 917 hydro, 1968 7hp sno-bee, 1968 190XTD
|
|