D-10 series III lift arms won't lower
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=204484
Printed Date: 22 Dec 2024 at 10:01am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: D-10 series III lift arms won't lower
Posted By: tractorboy
Subject: D-10 series III lift arms won't lower
Date Posted: 10 Dec 2024 at 11:44am
| So after 3 yrs finally got son's D-10 series III rebuild complete, first start last week. Seems great except lift arms raise by themselves every time when started. We had no hyd. problems at all before the rebuild , operators manual is 4 hrs. away at his house. Cant' figure out why sitting that long would cause this , any help appreciated, keith ,so va. |
Replies:
Posted By: DiyDave
Date Posted: 10 Dec 2024 at 3:24pm
Likely the TB linkage is amuck. It's the 2 little levers by your right hip as seated in the OP. I can't exactly tell you which way to position them, you will have to wiggle and test... ------------- Source: Babylon Bee. Sponsored by BRAWNDO, its got what you need! |
Posted By: 8070nc
Date Posted: 10 Dec 2024 at 3:26pm
|
Traction booster valve is stuck ------------- 1984 80780 1957 D14 DES 300 with 25000 engine 616 tractor |
Posted By: 8070nc
Date Posted: 10 Dec 2024 at 3:27pm
|
Or the linkage that works it ------------- 1984 80780 1957 D14 DES 300 with 25000 engine 616 tractor |
Posted By: Ltcmikesr
Date Posted: 12 Dec 2024 at 12:07pm
| Just get a om pdf on line. What i do. |
Posted By: 8070nc
Date Posted: 12 Dec 2024 at 5:40pm
|
Ive helped overcome that problem on at least 4 different tractors in the last couple years. Theres a spool in the hydraulic valve that does not have a hand operated lever attached to it. In front of that spool is a lever on a pivot that is attached to the linkage from traction booster and position control. On 2 tractors that pivot was froze up. On my D17 series 4 the sping on the back or the spool was binding and needed attention. If you cant figure it out ill give you my phone # and ill try to talk you thru it. Ill guve it to you anyway. Donald Matthews 910 824 8856 Leave a message. I dont answer calls i dont recognize ------------- 1984 80780 1957 D14 DES 300 with 25000 engine 616 tractor |
Posted By: tractorboy
Date Posted: 12 Dec 2024 at 11:50pm
| Thanks, I seem to have fiddled with it enough to make it work. Thanks keith so va |