185 Bell housing?
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=204244
Printed Date: 23 Nov 2024 at 2:11am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 185 Bell housing?
Posted By: Eric B
Subject: 185 Bell housing?
Date Posted: 20 Nov 2024 at 2:54pm
|
Would a 185 bell housing pattern match a 262 cu. in. from a Gleaner? The 185 engine is seized and needs to be replaced. Thanks to those 'in the know'. ------------- Currently- WD,WC,3WF's,2 D14's B. Previously- I 600,TL745,200,FL9,FR12,H3,816 LBH. Earth has no sorrow that Heaven cannot heal! |
Replies:
Posted By: HudCo
Date Posted: 20 Nov 2024 at 4:06pm
| thats one giant step backwards i would look for another 301 with money for the 262 for some one working on a d series |
Posted By: allisorange
Date Posted: 20 Nov 2024 at 5:35pm
|
I would go along with that. Look for a 301 like he said. |
Posted By: Eric B
Date Posted: 20 Nov 2024 at 11:03pm
While I appreciate your words of wisdom the question still remains wether the two have the same bolt pattern? ------------- Currently- WD,WC,3WF's,2 D14's B. Previously- I 600,TL745,200,FL9,FR12,H3,816 LBH. Earth has no sorrow that Heaven cannot heal! |
HudCo wrote:Posted By: DrAllis
Date Posted: 21 Nov 2024 at 6:05am
| It has been a very long time since I was up inside the engine bay on a Gleaner C-2 or model F. I think if the engine is equipped with a cast iron tail shaft housing, I'd say no. I just don't remember that backplate as being tractor friendly. If the combine engine backplate has those large 3/4" holes for the tractor side frames, then yes, I think it can be made work. |