Farm Equipment - a-c 200 pto output seal

Print Page | Close Window

a-c 200 pto output seal

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=20390
Printed Date: 09 Feb 2025 at 7:04pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: a-c 200 pto output seal

Posted By: papa_t
Subject: a-c 200 pto output seal
Date Posted: 05 Nov 2010 at 10:23am

does the lift shaft housing have to come off to replace rear pto seal on a 200.If so is there any thing unusal to look for?

Replies:

Posted By: Hurst
Date Posted: 05 Nov 2010 at 12:35pm

Is this a 2spd PTO. If so, it should be the same as a 7000, in which yes it does have to come off, as all the shafts and gears come out the side of the lift housing that is facing inside the rear end. Not really that bad of a removal if you have a good cherry picker (or a loader is what I used, probably not the safest...). One thing to make sure is that the PTO shaft that is inside the rear end housing just slides into a coupler at the rear. I would take off the rear end cover plate and have someone hold that shaft back in the tractor as you pull the housing off. If it comes out, there is a chance you can damage the seal between the compartments. I believe a single speed PTO can be done just by unbolting the carrier housing.

Hurst

-------------
1979 Allis Chalmers 7000
5800 Hours