Farm Equipment - Welding spindle support

Print Page | Close Window

Welding spindle support

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=202732
Printed Date: 23 Nov 2024 at 11:49am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Welding spindle support

Posted By: PTOman
Subject: Welding spindle support
Date Posted: 16 Aug 2024 at 1:34pm

52 CA spindle support weld which have been previously rewelded broke and I need to get some ideas on what size and type of welding Arc rod to use and amperage anybody has had some experience with this thank you

Replies:

Posted By: Clay
Date Posted: 16 Aug 2024 at 1:49pm

I just welded my 1962 gas D-17 spindle support about a week or two ago.

The crack was discovered when I greased the support. Grease was leaking from the bottom side of the top of the support.

I degreased the area the best I could. Ground a deep chamfer into the crack.

My first pass caused the grease to heat and run out.

I then used a rose bud to heat the crack until the grease no longer was running out.

Reground the area to be welded.

Welded with 7018 (1/8") at 95 amps.

After each weld, the weld was ground down. This was done to insure there were no slag inclusions.

I just checked the weld with dye penetrant and no crack was present.

This tractor has a 500 loader and is used primarily to move large round bales.

I suspect the spindle are was cracked when the lights went out and the tractor contacted a 9" diameter post. Good thing the tractor was at idle speed.

Posted By: steve(ill)
Date Posted: 16 Aug 2024 at 5:16pm

i use 7018 rod 3/32 diameter on almost everything.. Set about 90 amps.. You have to VEE out the crack to the bottom and weld out so there is no left over "crack" to start a second failure.. I grind all the metal to clean, no rust, no paint within 1/2 inch of the weld.. No preheat is needed if the parts are less than 1/2 inch thick, but if the metal is below 30 degrees, i preheat the area to get up above 100 degrees.

-------------
Like them all, but love the "B"s.