Farm Equipment - 8030 Trans Filter Light

Print Page | Close Window

8030 Trans Filter Light

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=201857
Printed Date: 27 Nov 2024 at 11:31pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 8030 Trans Filter Light

Posted By: dnel45
Subject: 8030 Trans Filter Light
Date Posted: 18 Jun 2024 at 8:33am

Had ‘Trans Oil Filter’ light come on our 8030 PS today. Filter was changed approximately 90 hours ago. Complete fluid change approximately 200 hours ago. 3400 hours on tractor. Oil level fine. What would cause this? Should filter be changed again? Bad sensor?

I should add that it was about 95 degrees out when it came on. It went off on the end rows when we let it sit but eventually stayed on the whole time. We went back to the barn with it. Pulling a Kinze 3500 planter with hydraulic drive.

Also - no change in performance, shifts flawlessly.

Replies:

Posted By: 8070nc
Date Posted: 18 Jun 2024 at 1:55pm

Id start with the sensor. Had a engine oil pressure switch go bad on a 8070. Light came on in the field. Shut it down immediately. Put a guage on it and it had great oil pressure. They do fail all of a sudden

-------------
1984 80780
1957 D14
DES 300 with 25000 engine
616 tractor

Posted By: JPG AUSTRALIA
Date Posted: 18 Jun 2024 at 6:55pm

Check for the sender wire rubbed through and grounding

Posted By: 8070nc
Date Posted: 18 Jun 2024 at 8:47pm

Thats a good suggestion. Wire grounding is a real possibility

-------------
1984 80780
1957 D14
DES 300 with 25000 engine
616 tractor

Posted By: SilverShoes
Date Posted: 20 Jun 2024 at 9:56am

I’d check your wiring, common issue with the light coming on.