Farm Equipment - 175 Allis lift cylinder rebuild

Print Page | Close Window

175 Allis lift cylinder rebuild

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=201845
Printed Date: 24 Nov 2024 at 2:40am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 175 Allis lift cylinder rebuild

Posted By: kenney58
Subject: 175 Allis lift cylinder rebuild
Date Posted: 17 Jun 2024 at 11:53am

I had read once on replacing cylinder seals on the 3 point lift. Am unable to remove pin in the front of cylinder in front of axle housing. And advice?

Replies:

Posted By: DSeries4
Date Posted: 17 Jun 2024 at 3:10pm

Going to need some heat and penetrating oil. Have done it several times. Removing the floor pan and traction booster linkage helps a lot.

-------------
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '61 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080

Posted By: 8070nc
Date Posted: 17 Jun 2024 at 3:18pm

I know D17s4 cylinders and 175 cylinders are probably different but on my D17 i plan to just take the pin out of the rod end screw the cap out pull the rod out and leave the tube on the tractor. Am i think wrong for some reason

-------------
1984 80780
1957 D14
DES 300 with 25000 engine
616 tractor