D19 Rear Axle Question
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=201626
Printed Date: 27 Nov 2024 at 10:28pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: D19 Rear Axle Question
Posted By: WIAllisFan
Subject: D19 Rear Axle Question
Date Posted: 03 Jun 2024 at 10:35am
|
I've had what I believed to be a leaky rear outboard axle seal for a while now, and while I was in the process of replacing the rim on that side this weekend I thought we should go after that seal as well. I'm waiting on the service manual(AC-202) to come in the mail but this question is bugging the daylights outta me. When I got the cap off I found what seemed to be an old very rotted out gasket or seal that would have been between the axle bearings and the cap for for the final drive. I don't have good pic of the material but you can see a little chunk of it at the bottom of the housing next to the outer ring of the axle. Is there supposed to have been a seal between the axle bearing and the cap? Seems to me there shouldn't be because I would think the outboard axle seal and the o-ring on the cap would be good enough, but I'm not sure. Anyone have a picture of the final drive assembly from the manual they can post? And while I'm there should I replace the bearing as well? There is about 1/8" of play in and out, and none up and down play.  |
Replies:
Posted By: Boss Man
Date Posted: 03 Jun 2024 at 8:11pm
| There are shim's under the cap that adjust axle end play. I dont remember if Allis used paper or tin shim's |
Posted By: Boss Man
Date Posted: 03 Jun 2024 at 8:23pm
|
Posted By: WIAllisFan
Date Posted: 05 Jun 2024 at 1:56pm
| Thanks Boss Man! |