Farm Equipment - wd lift arms on d17rock shaft

Print Page | Close Window

wd lift arms on d17rock shaft

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=199699
Printed Date: 24 Sep 2024 at 1:32am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: wd lift arms on d17rock shaft

Posted By: HudCo
Subject: wd lift arms on d17rock shaft
Date Posted: 06 Feb 2024 at 9:03pm

can i put the lift arms fron a wd on the rock shaft on a series 1 d17 and useing the wd lift cylinders with the cylinder inside

Replies:

Posted By: DrAllis
Date Posted: 07 Feb 2024 at 6:00am

Don't think you'll have enough spline length to do that. Maybe, but I don't think so.

Posted By: PaulB
Date Posted: 07 Feb 2024 at 6:31am

#1 Why would you want to do this?

#2 the WD/WD45 lift cylinders attached to a separate arm than the actual lift arms.

#3 if you are looking for extra lift capacity, there was a kit to add external lift cylinders.

-------------
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY

Posted By: HudCo
Date Posted: 07 Feb 2024 at 11:35am

paul b #3 yes i seen one of those kits thinking i could make some brackets to fit on the axle tube mounting with longer studs , dont remeber what the mounting looked like onthe kit that goes on the tractor side , if it bolted to the axle or some where easle, will try to get out to the wd and measure the splines and weasure the d17 splines . are they tapered ?

Posted By: HudCo
Date Posted: 07 Feb 2024 at 11:56am

never mind not nearly long enought lenght on the d17 splines so i will make the parts like the kit i know some one had a picture of it not long ago but a part number would be good if some one knows what it is so i can look it up, and may be locate one or fab the parts

Posted By: PaulB
Date Posted: 07 Feb 2024 at 6:56pm

The arms that bolt to the lift arms for the extra capacity D17 package are very much like the bolt on pieces that the forward control rods attach to for front mount cultivators. So that might be a place to start look for parts.

-------------
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY

Posted By: HudCo
Date Posted: 07 Feb 2024 at 8:12pm

thanks i am going to get in the agco book and take a look right now

Posted By: HudCo
Date Posted: 07 Feb 2024 at 8:54pm

no luck finding pictures or part number in parts book but probley didnt word it right on web searches will lok some more tommorrow