Print Page | Close Window

6140 Hyd level check

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=199477
Printed Date: 11 Nov 2024 at 11:10pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: 6140 Hyd level check
Posted By: orangereborn
Subject: 6140 Hyd level check
Date Posted: 25 Jan 2024 at 5:15pm
someone contacted me as to where the Hyd level check is on the 6140. Don't have one and don't know... ???  For starters I told him to check around the seat and shift lever area.   Thanks. Dale



Replies:
Posted By: AC720Man
Date Posted: 27 Jan 2024 at 11:07pm
Dale I’m going out on a short limb here but I think it was mainly sheet metal changes, there were some other changes but it’s basically a 160. Look down to the right side of the seat and look for a round plug that a 3/8” drive socket wrench fits in to remove it. Now that I think of it I may be confusing it with the 6040. Regardless that would be a good place for him to check.

-------------
1968 B-208, 1976 720 (2 of them)Danco brush hog, single bottom plow,52" snow thrower, belly mower,rear tine tiller, rear blade, front blade, 57"sickle bar,1983 917 hydro, 1968 7hp sno-bee, 1968 190XTD


Posted By: tbran
Date Posted: 27 Jan 2024 at 11:53pm
Sort rubber like plug on shift cover under seat with dipstick on it. It is a 6140 not a 6040.



-------------
When told "it's not the money,it's the principle", remember, it's always the money..


Posted By: DSeries4
Date Posted: 28 Jan 2024 at 9:51am
Originally posted by AC720Man AC720Man wrote:

Dale I’m going out on a short limb here but I think it was mainly sheet metal changes, there were some other changes but it’s basically a 160. Look down to the right side of the seat and look for a round plug that a 3/8” drive socket wrench fits in to remove it. Now that I think of it I may be confusing it with the 6040. Regardless that would be a good place for him to check.


160 Turned into the 6040.  The 6140 is a completely different animal from Japan.


-------------
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '61 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080


Posted By: orangereborn
Date Posted: 28 Jan 2024 at 4:49pm
Thanks gentlemen. I went digging in the book boxes and found an Operators manual. It was what you suggested and I had offered originally. Sent him some pictures. That little tractor with front wheel assist has always been on my list.. but after hauling a couple of those and both had front end problems I started to wonder.. Dale



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net