Allis Chalmers D17 Propane Side Shields
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=198588
Printed Date: 12 Nov 2024 at 1:41am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Allis Chalmers D17 Propane Side Shields
Posted By: CORY
Subject: Allis Chalmers D17 Propane Side Shields
Date Posted: 07 Dec 2023 at 11:37am
|
Are the bottom halves the same as a gas tractor? Or does anyone have a picture of a set off the tractor? Just trying to figure out what is missing on my recently acquired propane.
Thanks Cory
|
Replies:
Posted By: Gary
Date Posted: 07 Dec 2023 at 6:07pm
Here is a Link to pictures of a D-17 Propane which has side panels below the Propane Cylinder.
G
https://www.mecum.com/lots/322759/1958-allis-chalmers-d17-lp/" rel="nofollow - https://www.mecum.com/lots/322759/1958-allis-chalmers-d17-lp/
|
Posted By: Macon Rounds
Date Posted: 07 Dec 2023 at 9:04pm
You can make them out of gas tractor side panels.
However
There is an additional panel/cover that goes between tank and instrument panel.
It most often is missing.
-------------
The Allis "D" Series Tractors, Gravely Walk behind Tractors, Cowboy Action Shooting !!!!!!! And Checkmate
|
Posted By: IBWD MIke
Date Posted: 08 Dec 2023 at 8:58am
Cory, is you're tractor an original propane or a conversion? They did quite a few conversions on 45's, I assume they did 17's too. At any rate, the sheet metal would be different.
|
Posted By: CORY
Date Posted: 08 Dec 2023 at 10:26am
|
Factory LP Series II. The shield underneath the tank going around to both sides is there. It appears as in the picture that was posted as well as on mine that the side panels from a Gas would bolt right in there.(I have not taken the time to try as the tractor is currently at work and not at home) What is odd is there is part of the one underneath the tank on left side as sitting in the seat but it appears to be a factory? cut right where the steering shaft comes in at an angle. I would gladly text pictures to someone that knows how to post them on the site.
|
Posted By: Mikez
Date Posted: 09 Dec 2023 at 7:54am
|
Parts book just lists same panels for both gas and lp. Just has additional panel extension under tank.
|
|