Farm Equipment - D17 series 1 , 1958 PTO driven gear removal

Print Page | Close Window

D17 series 1 , 1958 PTO driven gear removal

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=198246
Printed Date: 24 Sep 2024 at 7:23pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: D17 series 1 , 1958 PTO driven gear removal

Posted By: Allis_1
Subject: D17 series 1 , 1958 PTO driven gear removal
Date Posted: 15 Nov 2023 at 9:38pm

Anyone have experience removing PTO driven gear and shaft. I need to replace bearing on intermediate gear and shaft. In order to do this manual states to remove PTO driven gear and shaft. I have removed snap ring and trying to use bump hammer to pull shaft and PTO bearing but it will not budge. wondering if anyone has any ideas or has done this before?

Replies:

Posted By: DrAllis
Date Posted: 15 Nov 2023 at 10:53pm

It takes a BIG slidehammer. I had one (only one) that I did have to heat the rear outer race quite hot, let cool and then slide hammer it. The race was junk from doing that, but that's what it took to get it pulled.