Starter on 190xt stuck running
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=197812
Printed Date: 12 Nov 2024 at 6:23am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Starter on 190xt stuck running
Posted By: Mattman
Subject: Starter on 190xt stuck running
Date Posted: 21 Oct 2023 at 7:09am
|
I moved my 190xt in the shed the other day and when I shut it off, the starter was still running. It was not engaged to the flywheel but still running. It even ran after I shut key off. I had to run to shop and get a 1/2 inch wrench and take battery cable off. Have any of you fellas run into this? I'm assuming the solenoid is sticking. Would this be the correct assumption?
|
Replies:
Posted By: DSeries4
Date Posted: 21 Oct 2023 at 8:40am
most likely
-------------
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '61 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080
|
Posted By: RedHeeler79
Date Posted: 21 Oct 2023 at 1:54pm
|
Possible starter button stuck or failed (if equipped with a button) keyswitch failed, or signal wire going to start terminal on solenoid shorted to battery power somewhere…. check these possibilities before throwing a new solenoid or starter at it.
|
Posted By: RedHeeler79
Date Posted: 21 Oct 2023 at 2:03pm
|
Unhook the signal wire from starter, then hook battery back up. (Make sure its in neutral and fuel shutoff is in off position first!! Or pull coil wire if its a gasser) if starter spins, solenoid is stuck. If starter doesn’t spin, check for 12v on signal wire without turning keyswitch or pushing starter button, before trying to hook the wire back up to starter solenoid (to rule out a short, or failed switch). Sometimes solenoid will hang up and not kick back out until power is disconnected, then will act normal again.
|
|