Classifieds - WTB 2300 disk gang bolt

Print Page | Close Window

WTB 2300 disk gang bolt

Printed From: Unofficial Allis
Category: Other Topics
Forum Name: Classifieds
Forum Description: For sale or wanted items
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=197777
Printed Date: 27 Sep 2024 at 2:32pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: WTB 2300 disk gang bolt

Posted By: Mikez
Subject: WTB 2300 disk gang bolt
Date Posted: 18 Oct 2023 at 10:52pm

Hello

I’m looking for a gang bolt for 2313. 13’ wide disk. The parts book says the gang bolt is 74-1/2” long. Original part number 586971.

Thanks

Replies:

Posted By: PaulB
Date Posted: 19 Oct 2023 at 5:48am

Send the specs to Shoup and have them make you one.

-------------
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY

Posted By: Mikez
Date Posted: 19 Oct 2023 at 6:14pm

Thanks Paul but they won’t do hexagon shaft.

Wondering if you switched to square and square bearings

Posted By: Mikez
Date Posted: 28 Oct 2023 at 10:04pm

Bump

Posted By: Mikez
Date Posted: 05 Dec 2023 at 8:37am

Btt

Posted By: Ray54
Date Posted: 05 Dec 2023 at 9:36am

Weld what you have. V it out to just little point, then start with 7018. Give it plenty of time, spend more time cleaning slag than welding. Chip and then wire wheel, make it shin. Then another pass. Lay it in a piece of angle iron, keep turning it at each weld pass to keep it straight. It is hours not minutes spent to get it right.

I have welded the round axles in a medium heavy duty offset drag disc. I have never broke one of my welds, and I am not one of the worlds best welders. I welded them to have a nut on both ends to make replacing broken blades faster. I farm over many rocks.

Posted By: Mikez
Date Posted: 26 Dec 2023 at 11:13pm

Ours is bent not broken

Posted By: truckerfarmer
Date Posted: 27 Dec 2023 at 6:47am

Could it be straightened? 20 ton shop press might do it. Or weld something to it so it won't roll, then wail on it with a sledgehammer. Another option would be to cut a v notch into the high side, then pound it straight. Then weld the notch full. Depending on the bend, might have to notch it in a couple spots.

-------------
Looking at the past to see the future.
'53 WD, '53 WD45, WD snap coupler field cultivator, #53 plow,'53 HD5B dozer

Duct tape.... Can't fix stupidity. But will muffle the sound of it!

Posted By: Ron(AB)
Date Posted: 30 Dec 2023 at 11:24pm

I second straighten it.

I had a bent shaft on a 2600 disk and straightened it on my press. It works good.

-------------
405, 7000, 7050, 8050, 8070, L3, 2300 & 2600 disk