Print Page | Close Window

226 engine

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=197356
Printed Date: 12 Nov 2024 at 7:59am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: 226 engine
Posted By: acd17toy
Subject: 226 engine
Date Posted: 24 Sep 2023 at 6:13pm

  Recently bought a WD45 at the end of the engine serial number is the letters  OH. 
  what does these letters mean?



Replies:
Posted By: DaveKamp
Date Posted: 24 Sep 2023 at 9:09pm
Perhaps a rebuilder stamped it OH to signify that they had performed an overhaul?


-------------
Ten Amendments, Ten Commandments, and one Golden Rule solve most every problem. Citrus hand-cleaner with Pumice does the rest.


Posted By: Lon(MN)
Date Posted: 25 Sep 2023 at 7:12am
H was propane. PA was gas engine.

-------------
http://lonsallischalmers.com


Posted By: Brian G. NY
Date Posted: 25 Sep 2023 at 11:35am

Post the entire engine serial number; perhaps the O is actually a 0?

If the tractor is a WD, the engine number will be WD-XXXXXX  followed by one or two letters.
In this case PA or GA (late) indicates Gasoline,  K (or KA) indicates Kerosene or distillate and H (or HA) indicates "High Altitude".
 
If the tractor is a WD-45, the serial number should consist of 45- XXXXXX  followed by 1 or 2 letters indicating fuel type. eg: G or GA for gasoline. 
I can't find the fuel suffix letters for the WD-45 other than gasoline  but I am going to assume they may be the same as the late WDs.

I can't find any specific letter designations for the WD-45 propane tractors but I see that piston part number 223507 is used for both the WD low octane fuel tractors (5.00:1) as well as the WD-45 Butane, LP gas and gasoline powered tractors (7.2:1). The wide variation in compression ratios must be a result of the 4" vs 4.5" stroke.

It seems I have seen a few other variations in the last two digits of engine serial numbers over the years but, unfortunately, I didn't make note of them at the time.

Sorry for the long post, lot of stuff to cover here.

After all this, I hope you do find an answer to your seemingly simple question. LOL



Posted By: acd17toy
Date Posted: 25 Sep 2023 at 6:19pm

   Cleaned the end of the engine serial number better the letters are GH, the tractor is   a   WD45, according to the serial number over 200 hundred was built before it was.


Posted By: TramwayGuy
Date Posted: 25 Sep 2023 at 8:06pm
“..   Cleaned the end of the engine serial number better the letters are GH..”

Is it possible the letters are ‘GA’? That would be more likely.


Posted By: Brian G. NY
Date Posted: 26 Sep 2023 at 10:15am
Originally posted by TramwayGuy TramwayGuy wrote:

“..   Cleaned the end of the engine serial number better the letters are GH..”

Is it possible the letters are ‘GA’? That would be more likely.

I agree with Tram; by far, the greatest number of WD-45s had GA (gasoline) as a serial number suffix.


Posted By: acd17toy
Date Posted: 26 Sep 2023 at 6:18pm


  The letter is  a clearly  H.  Could this engine be one built for a high altitude  area? 


Posted By: Brian G. NY
Date Posted: 27 Sep 2023 at 8:56am
Please post the entire engine serial number!



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net