Hydraulic cables
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=196637
Printed Date: 12 Nov 2024 at 10:49am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Hydraulic cables
Posted By: allis/cattle
Subject: Hydraulic cables
Date Posted: 12 Aug 2023 at 2:16pm
|
How is a person supposed to run the hydraulic control cable from the valve to the handle on a 7040 with serial number 1982? I got a cable from ago but it seam short. The tractor has triple remotes. This is the third cable I’ve put on in 10 years . Bunker hill cable is not an option cause they don’t ship to Canada
|
Replies:
Posted By: Lynn Marshall
Date Posted: 12 Aug 2023 at 7:54pm
|
If it still has the smaller ,3/16 size cables, then the tallest lever uses a different cable than the other two levers. Tall lever use 70269207 and the other levers use 70268511. The larger,1/4 inch cables, are the same for all three levers.
|
Posted By: allis/cattle
Date Posted: 12 Aug 2023 at 9:30pm
|
I knew that part I’m just having trouble routeing them properly
|
Posted By: DrAllis
Date Posted: 13 Aug 2023 at 6:12am
|
Routing ?? They connect to the appropriate lever and pretty much go straight out thru the rear cab wall and curl around to the valve. If your cable is too SHORT, it ptobably won't reach.
|
Posted By: Lynn Marshall
Date Posted: 13 Aug 2023 at 6:59am
|
Yes,the route should be the same as the old one that was taken out and very similar to the other remote cables already there. A new agco cable probably has a part number on it to verify that it's correct for your application.
|
Posted By: Lars(wi)
Date Posted: 13 Aug 2023 at 7:59am
How did you replace it, the previous times?
-------------
I tried to follow the science, but it was not there. I then followed the money, and that’s where I found the science.
|
Posted By: allis/cattle
Date Posted: 13 Aug 2023 at 4:04pm
|
I just managed to get it the other times. I did figure out today that my #1 lever was connected to #3 valve so I swapped them around and it’s ready to go
|
|