175 diesel front end bushings
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=195400
Printed Date: 01 May 2024 at 3:38pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 175 diesel front end bushings
Posted By: Josh(NE)
Subject: 175 diesel front end bushings
Date Posted: 27 May 2023 at 3:03pm
|
Working at tightening up my front end and there appears to be a bushing in the diesel engine adapter plate for the rear bolt to hold the back end of the axle assembly. I cannot find a part number in the agco parts book. Has this been added or should a part number be available? Thanks ------------- Allis Express '65 190XT, 37 B, '72 170, '83 8030, and the IH 560 was a mistake |
Replies:
Posted By: DrAllis
Date Posted: 27 May 2023 at 5:47pm
| They don't show one with the front axle or the diesel engine adapter plate. I have no experience with the Perkins engine installations in those tractors. This I know: if the axle rear pivot bolt nut was T-I-G-H-T like it should have always been, there would be no wear whatsoever on that bushing. Over the decades I have tightened that rear pivot bolt on D-17's thru 200 tractors for being loose and I've never had one re-loosen that I know of. They must be TIGHT !! so they can't start wallering out the hole !! |
Posted By: steve(ill)
Date Posted: 27 May 2023 at 6:39pm
how about measure the bore size and bolt size and see if it is WORN, or room for a bushing... McMaster Carr and others will sell various bushings.
 ------------- Like them all, but love the "B"s. |
Posted By: Josh(NE)
Date Posted: 27 May 2023 at 8:15pm
|
Steve that is the path I figured I would be going. Thanks ------------- Allis Express '65 190XT, 37 B, '72 170, '83 8030, and the IH 560 was a mistake |
Posted By: steve(ill)
Date Posted: 27 May 2023 at 8:31pm
|
if the hole is just wollared out ... and possibly not round... I have used an air powered die grinder to cut / enlarge / round out the hole before installing a bushing.... easier than removal / drill press. ------------- Like them all, but love the "B"s. |
Posted By: Josh(NE)
Date Posted: 28 May 2023 at 9:52am
|
Hole is good. Just a worn bushing. ------------- Allis Express '65 190XT, 37 B, '72 170, '83 8030, and the IH 560 was a mistake |