7050 3 point
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=194858
Printed Date: 23 Aug 2025 at 12:14am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 7050 3 point
Posted By: Trenthorn
Subject: 7050 3 point
Date Posted: 27 Apr 2023 at 8:30pm
My 7050 3 point does go all the way up. never really used it till we put our 10ft blade on it and it doesnt go all the way. The top arms are about 6inches or little more from the windows. Cable is new. Just wanted some insight on where to go from here.
-------------
1956 WD45, 1970 190xt Series 3, 712,716,917
|
Replies:
Posted By: DrAllis
Date Posted: 27 Apr 2023 at 8:32pm
|
Better re-read what you wrote. The hitch DOES go all the way up?? or DOES NOT go all the way up? ? With nothing on the hitch, raise it all the way up. Walk to the back of the tractor and grab one draft arm and lift it up to see if the upper lift arms will go any higher. A weak back ?? Get someone strong or use a cherry picker. The lift arms should NOT go 100% to the top, because that is bottoming out the hydraulic cylinder inside, which is a bad thing AND if it is bottomed out, the hydraulic pump is pressurized all the time, which also isn't good. So, in the end, you want the lift arms to be a couple inches short of being 100% fully up. New control cable?? maybe needs to be shorter if hitch height is truly low. Need the blade to go higher ?? Put the top link in the lower hole on the tractor, NOT the top hole.
|
Posted By: MACK
Date Posted: 27 Apr 2023 at 9:12pm
|
Shorten the 3/8 rod that pins to right lift arm if every thing is properly adjusted. MACK
|
Posted By: Trenthorn
Date Posted: 27 Apr 2023 at 9:16pm
Dr allis sorry just seen that. The lift works fine but does not go all the way up I can pick the arms up another six inches at least before it hits the top. The inside of the draft arms are just touching the bottom of the top sway block. I tried to attach a picture but it's to big.
-------------
1956 WD45, 1970 190xt Series 3, 712,716,917
|
Posted By: captaindana
Date Posted: 28 Apr 2023 at 4:48am
Trenthorn…email your pic to yourself and send it smaller or medium size to yourself and it will fit just right.
-------------
Blue Skies and Tail Winds
Dana
|
|