Farm Equipment

Print Page | Close Window

Wiring

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=19475
Printed Date: 08 Feb 2025 at 3:06am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Wiring

Posted By: Rod in MN
Subject: Wiring
Date Posted: 15 Oct 2010 at 11:25am

Hi agine just need wiring digram on WD 45 with 12 volt generator and 12 voltage VR . Well useing the oli light switch . the points coil and light all have been change THATS ALL

Thank You

Rod IN MN

Replies:

Posted By: Dnoym N. S. Can.
Date Posted: 15 Oct 2010 at 7:42pm

this is a site that tell you a
lot about generator and regulator
http://www.ytmag.com/articles/artint4.htm - http://www.ytmag.com/articles/artint4.htm
HTH
B:-) Dnoym

Posted By: CTuckerNWIL
Date Posted: 15 Oct 2010 at 7:48pm

The original light switch is a resistor switch which works with the cut out relay in the original 6v pos ground set-up. If you are going to 12v with a regulator, ditch the resistor switch for a simple 2 place on off switch. I seriously doubt you will find any diagram of a 12 volt genny and V regulator showing the 3 position switch since it is made to control the cut out relay which you don't have anymore.

-------------
http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com
Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF

Posted By: Dnoym N. S. Can.
Date Posted: 15 Oct 2010 at 7:51pm

or this one depanded on what generator
you have
http://www.ytmag.com/articles/artint29.htm - http://www.ytmag.com/articles/artint29.htm
B:-) Dnoym