Model G manifold
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=194074
Printed Date: 20 Dec 2024 at 11:34am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Model G manifold
Posted By: pungobob
Subject: Model G manifold
Date Posted: 15 Mar 2023 at 8:22am
| Good morning all. New member here and am glad to have found this forum. I just my first restoration project a 1951 Model G. Previous owner butchered the manifold trying to remove the muffler. I have a replacement manifold on order and here is my question. I removed the two nuts that are visible but the manifold appears to just be held on by the gasket. Is there anotherhidden nut that I don’t see or s it just the gasket holding the manifold to the block. Any input will be greatly appreciated. |
Replies:
Posted By: Alvin M
Date Posted: 15 Mar 2023 at 9:42am
| There are four nuts that hold in on |
Posted By: pungobob
Date Posted: 15 Mar 2023 at 9:57am
| Thanks Alvin, I didn’t want to banging it a big hammer without checking. I’ll look for the other two. |
Posted By: steve(ill)
Date Posted: 15 Mar 2023 at 10:07am
look at the bolt holes in the gasket... ------------- Like them all, but love the "B"s. |
Posted By: pungobob
Date Posted: 15 Mar 2023 at 10:17am
| Well dang nw it all makes sense. Sometimes ya can’t see the forest for the trees. Thanks so much Steve. Have you had dealings with Steiner tractor parts? |
Posted By: steve(ill)
Date Posted: 15 Mar 2023 at 3:53pm
|
I have not had much dealings with Steiner... but they are a well known tractor parts company.. There are also a couple vendors on this site that sell parts... see "parts and service" at the top of the page... Depending on what you want, im sure many here can give you opinions.
------------- Like them all, but love the "B"s. |
Posted By: pungobob
Date Posted: 15 Mar 2023 at 4:03pm
| Thanks to all that responded to my question. Manifold is off ready for the new one. Thanks again. |