aetna clutch release bearing
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=193830
Printed Date: 25 Aug 2025 at 5:12am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: aetna clutch release bearing
Posted By: tractorboy
Subject: aetna clutch release bearing
Date Posted: 01 Mar 2023 at 9:23pm
I know it's new & packed tight with grease, but I can hardly turn this throw-out bearing by hand. Should be a good brand it's even written in my original service manual . It's for a d 10. Anybody had any experience with this?? thanks in advance, keith so.va.
|
Replies:
Posted By: DrAllis
Date Posted: 01 Mar 2023 at 9:27pm
| You have it pressed onto the shifter sleeve ?? or are holding it in your hand trying to turn it ?? |
Posted By: tractorboy
Date Posted: 01 Mar 2023 at 10:20pm
| in my hand |
Posted By: DrAllis
Date Posted: 02 Mar 2023 at 4:43am
| I think I'd assemble it and give it another turn test. |
Posted By: tractorboy
Date Posted: 03 Mar 2023 at 2:46am
| Ok I pressed it onto the shifter sleeve and the rear part of the bearing turns fine. I didn't realize on a throw out bearing there are two bearings. The front thrust face is the one that is tight. maybe the pressure of pushing against the release fingers will make it turn, thanks keith so.va. |