Reassembly ED40 Gear Box , Need Help
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=193693
Printed Date: 18 Nov 2024 at 5:31am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Reassembly ED40 Gear Box , Need Help
Posted By: John426
Subject: Reassembly ED40 Gear Box , Need Help
Date Posted: 23 Feb 2023 at 4:04am
|
I am reassembling the gear shift of my ED40 gear box. how to insert the rod shift and have the springs compressed? It is difficult doing that with only 2 hands? How to proceed?
 |
Replies:
Posted By: jaybmiller
Date Posted: 23 Feb 2023 at 7:39am
|
never ever done one but... GREASE ! use thick grease to hold ball and spring ?? I'm sure someone here will post his 'trick'..... ------------- 3 D-14s,A-C forklift, B-112 Kubota BX23S lil' TOOT( The Other Orange Tractor) Never burn your bridges, unless you can walk on water |
Posted By: steve(ill)
Date Posted: 23 Feb 2023 at 8:29am
|
is there a vertical pin hole to push the balls in, then slide a wire thru the pin hole to hold 3 balls.... then pull the wire out after rod is installed ?? ------------- Like them all, but love the "B"s. |
Posted By: MACK
Date Posted: 23 Feb 2023 at 8:42pm
| Make a T handle the size of rail. Grind a tapered V in the end to start over ball and spring. Start shaft through holes with ball and spring. Rotate shaft to push ball down. Move to next one and do same thing. Next push tool back out with rail and forks as they are to be assembled. MACK |