g2800 lp
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=193096
Printed Date: 27 Apr 2024 at 2:53am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: g2800 lp
Posted By: HudCo
Subject: g2800 lp
Date Posted: 25 Jan 2023 at 9:44am
| going to go look at a tractor for parts 190 xt with a g2800 lp so i do not know any thing about the enginge but it looks like a lot higher compression (on tractor data) mostly interested in the engine for a puller other parts on the tractor have been robbed what is the crankshaft nut size so i can take a wrench with to turn the engine over |
Replies:
Posted By: DrAllis
Date Posted: 25 Jan 2023 at 10:59am
| 1 5/16" wrench I think. |
Posted By: HudCo
Date Posted: 25 Jan 2023 at 11:20am
| so is this a good engine i did not even know that it exsisted untill i seen the tractor last summer |
Posted By: DrAllis
Date Posted: 25 Jan 2023 at 1:20pm
| They were fine but I'm sure suffered the same problem the regular gas models did.......the piston top could break off and the skirt was left going up and down in the sleeve. I don't believe there are any piston/sleeve kits available anymore for gas and surely not LPgas. If you want high compression for a puller, use diesel pistons and just mill open the bowl some more and get 12 or 13 to 1 compression. LPgas is only 9.3 to 1, I think. |
Posted By: MACK
Date Posted: 25 Jan 2023 at 8:35pm
| I might have a set if 4.1/8 forged pistons for it. Have a block bored for 226 AC sleeves. Call 660 663 9173. MACK |
Posted By: groundhog55
Date Posted: 26 Jan 2023 at 7:36am
| I think that I know were there is a set of piston and sleeves for that engine. |
Posted By: HudCo
Date Posted: 26 Jan 2023 at 9:30am
| could this engine go in place of the engine in a wd45d or d 17d or d19 and use as a farm tractor . 4 1/8 pistons and sleeves what c.i. does that come up to? might have to start a new post in the pulling section |
Posted By: DON G
Date Posted: 26 Jan 2023 at 7:09pm
I had one. 265ci.  Did not like it. Traded for 190XTD ,lots of power ran 9 years, lost hearing. Traded for 7000. big improvement.
|
Posted By: DrAllis
Date Posted: 26 Jan 2023 at 7:21pm
| A 265 cube engine was the G-2500 used in the 180 and 190, not a 190XT gas. Was only 75 HP on the 190. |
Posted By: MACK
Date Posted: 26 Jan 2023 at 8:46pm
| 4 1/8 bore makes it 340 ci. MACK |
Posted By: HudCo
Date Posted: 26 Jan 2023 at 10:32pm
| i am going to stop and look at it tomorrow i am thinking this will be puller matierel for the one pull we have a year |