Gleaner L2 Header Wobble BOX
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=19032
Printed Date: 07 Feb 2025 at 4:52pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Gleaner L2 Header Wobble BOX
Posted By: KY
Subject: Gleaner L2 Header Wobble BOX
Date Posted: 03 Oct 2010 at 6:22pm
|
I have a Hart Carter wobble box bearing down on on my gleaner header. I can not get the drive pulley off of the wobble box to access the bearing. Does the pulley unscrew? It has a nut made on it and it also had a jam nut against it that i have already removed. I have used heat and a long bar.
|
Replies:
Posted By: Adam Stratton
Date Posted: 03 Oct 2010 at 7:30pm
|
Heat, penetrating oil, long bar, are the only way to go. We couldnt break ours loose with our 1" impact wrench, so used 1" drive socket and handle, long cheater, and was able to get it that way. If you break the pulley (I broke 1) be prepared for major $$ for that matter, depending on the bearing you are probably looking at close to $100 right off the bat. I have several more to put together so we have a spare for fall harvest. Good luck!
|
Posted By: KY
Date Posted: 04 Oct 2010 at 7:52am
|
It doesnt unscrew backwards does it? In other words its not backwards thread is it?
|
Posted By: Adam Stratton
Date Posted: 04 Oct 2010 at 8:01am
|
Not to the best of my memory. Its been a while since I tore one apart last.
|
Posted By: KY
Date Posted: 05 Oct 2010 at 11:23am
|
Well We heat ,beat, cussed and used a 1" impact. The pulley busted off the nut but it still wont budge and its almost rounded off. Found another wobble box on a junk header to finish this year until I can fix that one. Pulley from AC is 460.00.
|
Posted By: skipwelte
Date Posted: 05 Oct 2010 at 12:21pm
|
After breaking a few of the pulleys, I stopped useing alot of heat, seems it changes the metal and it will break. A six point socket and a looong cheater bar, hitting the cheater with a sledge hammer helps-the guy holding the bar needs thick gloves.
|
Posted By: KY
Date Posted: 05 Oct 2010 at 2:12pm
|
Any of yall wouldnt happen to have an extra pulley laying around that you would sell do ya??? My extra wobble box turned out to be a bust and im not done with beans yet.
|
Posted By: corlewfarms
Date Posted: 05 Oct 2010 at 7:59pm
Posted By: Dave H (NE)
Date Posted: 05 Oct 2010 at 9:48pm
just cut the brg off with the torch, the pulley will come off easy and save you 460 bucks just did one today
|
Posted By: Amos
Date Posted: 05 Oct 2010 at 9:52pm
|
Dave, try the plasma cutter instead of the torch. Less heat and works faster. For some reason the pulley comes right off then. Doesn't ever seem to want to come off easy though, without the bearing off first.
|
|