ISO Power Steering Line for D17 series IV
Printed From: Unofficial Allis
Category: Other Topics
Forum Name: Classifieds
Forum Description: For sale or wanted items
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=190026
Printed Date: 07 May 2024 at 5:42am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: ISO Power Steering Line for D17 series IV
Posted By: thester
Subject: ISO Power Steering Line for D17 series IV
Date Posted: 11 Aug 2022 at 7:32pm
| Looking for power steering line for D17 Series IV. If sitting on tractor it is the small line on the left side. Runs from pump to left side of reservoir on from of tractor. |
Replies:
Posted By: DrAllis
Date Posted: 11 Aug 2022 at 9:28pm
| I'm going to assume a gas tractor ?? Diesel lines are all different. Lines from a series 3 are the same as a series 4. |
Posted By: thester
Date Posted: 12 Aug 2022 at 5:49am
Yes Sir. You are correct and thank you for the response. If I were to try and build a line myself. Would you know the size of the line # 5 and fittings? 
|
Posted By: DrAllis
Date Posted: 12 Aug 2022 at 6:33am
| That's the pressure line, so it must be good enough for 1600 psi. If you don't have your old one for a pattern, that will be a challenge to make one identical. The pump hole is "inverted flare" which is kind of odd. The bottom is too, but you could make it into JIC connections. |
Posted By: thester
Date Posted: 12 Aug 2022 at 7:18am
| I have the old one for a pattern and I should be able to reuse the fittings. I’m just unsure the exact size of the steel line. Once I have formed the line I should be able to have a high pressure hose attached. |
Posted By: Albert
Date Posted: 13 Aug 2022 at 7:53pm
|
I am sure it is a 5/8 line but you better measure it. A 5/8 open end quality wrench will tell you. Albert
|
Posted By: PaulB
Date Posted: 14 Aug 2022 at 6:27am
|
If you have the line; Send it to Inline Tube to have a replacement one copied from it. ------------- If it was fun to pull in LOW gear, I could have a John Deere. If you can't make it GO... make it SHINY |
Posted By: VaAllis1990
Date Posted: 14 Aug 2022 at 7:20pm
| Agco still sells it |
Posted By: Albert
Date Posted: 14 Aug 2022 at 7:35pm
| 70237389 NLA from AGCO |
Posted By: DSeries4
Date Posted: 15 Aug 2022 at 5:12pm
|
If you have the old one, a local hydraulic shop can make one to match it. ------------- '49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '61 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080 |
Posted By: thester
Date Posted: 08 Sep 2022 at 6:51am
| Thanks for all the responses. Found the line from a gentlemen in PA via EBay. |