190 transmission rear end oil level
Printed From: Unofficial Allis
Category: Other Topics
Forum Name: Pulling Forum
Forum Description: Forum dedicated to Tractor and Garden Pulling
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=187015
Printed Date: 26 Nov 2024 at 10:55pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 190 transmission rear end oil level
Posted By: brad7066
Subject: 190 transmission rear end oil level
Date Posted: 13 Mar 2022 at 7:42pm
|
how much over the full line should i be running my 190. it has a coupler in it with no hydraulics
|
Replies:
Posted By: DrAllis
Date Posted: 14 Mar 2022 at 9:17am
|
For pulling?? the higher the better, to flood the differential gears. Use light weight (HyGuard/HyTran/821XL/Permatran) oil, not 80/90 wt. Oil level can be as high as half-way submerging the top shaft in the transmission and then that will have the differential half submerged too. Needling the differential is a good thing.
|
Posted By: tbran
Date Posted: 14 Mar 2022 at 1:41pm
|
as to the front end - if you have no PD clutch - many take out the torque housing gears and put in sealed bearings so one needs no oil - IF you still have the torque housing gears we put oil jugs in bottom of center housing and foam to cut down on amount of oil needed -but you have to keep those cone/cup needle brgs in the front housing wet... about normal on RH dipstick...
-------------
When told "it's not the money,it's the principle", remember, it's always the money..
|
Posted By: brad7066
Date Posted: 14 Mar 2022 at 2:09pm
|
differential gears have been needled was told by them to run mystik synthetic.
|
Posted By: goomer
Date Posted: 14 Mar 2022 at 10:16pm
|
I drilled and taped a drain plug on the circle plate on side of torque housing just about even with clutch main shaft. I keep filling until oil comes out. Takes a bit of time to get oil there.
|
|