Farm Equipment - need gleaner help ASAP

Print Page | Close Window

need gleaner help ASAP

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=18577
Printed Date: 07 Feb 2025 at 6:23am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: need gleaner help ASAP

Posted By: clint
Subject: need gleaner help ASAP
Date Posted: 22 Sep 2010 at 8:32am

first- how do i wire the reel speed for a 316 head to an m2

second, how do i remove the cyl bars- i might get a new set- is it metric? are the backs welded in and i just turn the outside bolt?

-------------
Our farms stuff: agco gt55, AA 8775, 8765, 6080, 185, 180, 175, 170, d15, d14, d14, wd, wd, wd, g, F3, L3, R62

Replies:

Posted By: NEJim
Date Posted: 22 Sep 2010 at 8:50am

I'd have to look at the reel wiring but the cyl bars are just bolted on. There is a nut and lockwasher on the back. Make sure when you replace them you put them on in pairs with one across form the other.

Posted By: DanWi
Date Posted: 22 Sep 2010 at 8:43pm

Depending on the condition of the bolt heads on the cylinder bars you may just remove them with a torch just be careful not to burn the combine up.

Posted By: Adam Stratton
Date Posted: 22 Sep 2010 at 9:40pm

Ive always done the bars by removing the panel on top of the throat. I dont know for sure how the wiring is on the header, but all you really need to change is to run a wire from the reel speed button to the hydraulic reel control on the header. Good luck.

Posted By: Don M SEIA
Date Posted: 22 Sep 2010 at 9:43pm

I think there can be balance weights on the inside, been a long time since I did one. Don

Posted By: tbran
Date Posted: 23 Sep 2010 at 2:26pm

header is wired with either a dual pole dual throw switch that is cross wired like a actuator on a hay baler with electric motor for actuator. The wiring diagram is in the back of op man for factory wiring.

Posted By: 9675
Date Posted: 23 Sep 2010 at 3:51pm

Wires should be in harness by return to cylinder plugs should match head.

Posted By: michaelwis
Date Posted: 23 Sep 2010 at 4:25pm

Use a torch .. have a garden hose ready ..BETTER YET WET IT DOWN BEFORE .. make sure you turn the bars a 180 as the back ..(leading edge ) is not worn unless someone else turned them ..
Worthington ag parts ..may have a set ..not turned

-------------
WD WD45 DIESEL D 14 D-15 SERIES 2 190XT TERRA TIGER ac allcrop 60 GLEANER F 6060 7040.and attachments for all Proud to be an active farmer