Echo PB260L Blower
Printed From: Unofficial Allis
Category: Other Topics
Forum Name: Shops, Barns, Varmints, and Trucks
Forum Description: anything you want to talk about except politics
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=185014
Printed Date: 30 Oct 2025 at 7:31pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Echo PB260L Blower
Posted By: thendrix
Subject: Echo PB260L Blower
Date Posted: 08 Dec 2021 at 2:00pm
|
Blower cranks and idles great and revs to about 1/3 throttle and then that's all it's got. Not excessive smoke or noise. RPM stays the same through full throttle. It has a new air filter, new in tank fuel filter, new fuel line. Last used about 2 months ago and this is when the problem started. Used about 2 months before that and it ran great. Also has a new spark plug. I use it to blow dust off of and out of brooders in the chicken house and it's been run a TON between here and the old farm. The blower itself is probably 20 years old I guess. Any thoughts? I don't remember for sure but I believe the gas in that can is ethanol free. ------------- "Farming is a business that makes a Las Vegas craps table look like a regular paycheck" Ronald Reagan |
Replies:
Posted By: DiyDave
Date Posted: 08 Dec 2021 at 6:00pm
Not sure if it has an exhaust screen, but try that first, see if its clogged up. Also check the fuel filter, in the tank, at the end of the intake line. ------------- Source: Babylon Bee. Sponsored by BRAWNDO, its got what you need! |
Posted By: PaulW(NE)
Date Posted: 08 Dec 2021 at 6:02pm
|
Is there a spark arrestor on the muffler? Seen on Stihl's when they plug up will cause what your describing. |
Posted By: thendrix
Date Posted: 08 Dec 2021 at 6:53pm
|
I forgot to mention the screen. I did check it and it was clean. And I put a new in tank filter on it today. Also ran it without the gas cap so it shouldn't be a clogged vent. There's two lines at the carb. I'm assuming one is a return? I took it off and no change ------------- "Farming is a business that makes a Las Vegas craps table look like a regular paycheck" Ronald Reagan |
Posted By: jaybmiller
Date Posted: 08 Dec 2021 at 7:36pm
|
assuming it's a 2 stroke , do you have the proper ratio of gas/oil mix ? ------------- 3 D-14s,A-C forklift, B-112 Kubota BX23S lil' TOOT( The Other Orange Tractor) Never burn your bridges, unless you can walk on water |
Posted By: Stan IL&TN
Date Posted: 08 Dec 2021 at 8:29pm
|
Check to see if it has an H and an L adjustment on the carb. H is for adjusting the high rpm speed fuel mix and L is for adjusting low speed. Some or most used to have these adjustments before the EPA got involved. ------------- 1957 WD45 dad's first AC 1968 one-seventy 1956 F40 Ferguson |
Posted By: klinemar
Date Posted: 08 Dec 2021 at 8:56pm
| https://youtu.be/Aq1YLFKsboY" rel="nofollow - https://youtu.be/Aq1YLFKsboY |
Posted By: klinemar
Date Posted: 08 Dec 2021 at 8:59pm
| I really like this guy. He's Canadian. https://youtu.be/XFDvinWIkCY" rel="nofollow - https://youtu.be/XFDvinWIkCY |
Posted By: klinemar
Date Posted: 08 Dec 2021 at 9:15pm
| Here is a video of a guy working on a Echo leaf blower bogging down and fixing it. https://youtu.be/b87mR1fNrHI" rel="nofollow - https://youtu.be/b87mR1fNrHI |
Posted By: HD6GTOM
Date Posted: 08 Dec 2021 at 10:56pm
| Throttle cable almost broken, stretched out? Can you get your finger down inside and see if the throttle lever can be moved by hand, has a screw loosened up allowing the cable slip and not pull the throttle all the way open? Good luck with it. |
Posted By: DiyDave
Date Posted: 09 Dec 2021 at 4:53am
One thing about the video. If you take a grinder, and cut a small slit, across the threads of the drywall screw, it will go through the seal better. Once you are through the seal, use another screw of the same size, but dulled at the end, again with the grinder... ------------- Source: Babylon Bee. Sponsored by BRAWNDO, its got what you need! |
klinemar wrote:Posted By: WF owner
Date Posted: 09 Dec 2021 at 6:28am
|
Have you tried adding some Seafoam to your gas? Add it to the fuel tank and let it run for half an hour. I'm not usually a fan of additives, but I have had very good luck with Seafoam.
|
Posted By: Dave H
Date Posted: 09 Dec 2021 at 6:34am
|
I would look in the intake to make sure the throttle butterfly is opening fully. |
Posted By: thendrix
Date Posted: 09 Dec 2021 at 4:55pm
|
Checked throttle cable, butterfly, muffler screen again, air filter again, and fuel filter again. I can't find an adjustment screw anywhere on this carburetor. Or a plug where one should be. The gas is the same gas I run in the chain saw and have had no trouble with it what so ever. Jets in the carb seem to be clean. Started thinking maybe the muffler itself is stopped up rather than just the screen so I ran it without the muffler and no change. Also no change with the choke on or off. I'm at a loss ------------- "Farming is a business that makes a Las Vegas craps table look like a regular paycheck" Ronald Reagan |
Posted By: mdm1
Date Posted: 09 Dec 2021 at 5:36pm
|
Is there any chance the gas line is being crushed by something when you put it back together? I have a ryobi that did the same thing. ------------- Everything is impossible until someone does it! WD45-trip loader 1947 c w/woods belly mower, 1939 B, #3 sickle mower 1944 B, 2 1948 G's. Misc other equipment that my wife calls JUNK! |
Posted By: thendrix
Date Posted: 09 Dec 2021 at 7:36pm
|
I guess there's a possibility but it was doing the same thing before I took it apart and I didn't see any places on the old one that looked crushed or smashed. I'm sure it's something simple but I swear I just don't know. ------------- "Farming is a business that makes a Las Vegas craps table look like a regular paycheck" Ronald Reagan |
Posted By: Hubert (Ga)engine7
Date Posted: 09 Dec 2021 at 10:10pm
|
The rings or cylinder wall may be worn enough that you are losing compression but that should have come on gradually. If a new carb is not too expensive you might want to give that a try. Or just ask Cora and Evie if they can talk Santa into bringing you a new one for Christmas. ------------- Just an old country boy saved by the grace of God. |
Posted By: thendrix
Date Posted: 10 Dec 2021 at 5:55am
Evie and Cora can talk Santa into ANYTHING. They do it all year long  . This one is WELL used. My in-laws used it for about 20 years and we've used it for a couple since.------------- "Farming is a business that makes a Las Vegas craps table look like a regular paycheck" Ronald Reagan |
Posted By: thendrix
Date Posted: 10 Dec 2021 at 12:16pm
Well... Bit the bullet and bought a Stihl 450. Nobody around has any Echo backpack blowers for some reason  . It's a little heavier than the Echo was but we'll see if that's a problem in a little while. Thanks for everybody's help/insight ------------- "Farming is a business that makes a Las Vegas craps table look like a regular paycheck" Ronald Reagan |
Posted By: Dave H
Date Posted: 10 Dec 2021 at 2:13pm
|
Agreed that it was time to throw n the towel. You getting that Stihl reminds me of the neighbor's last back pack Stihl blower purchase. Now that was over head, it even had electrical start which he demonstrated.  |
Posted By: thendrix
Date Posted: 10 Dec 2021 at 7:40pm
|
Put about 2 hours on the Stihl this evening. The heavier blower isn't that noticable but the throttle/hose handle is a little to close to the motor case and it gets uncomfortable to use up in the air. I need to find out if they have an extra piece to move the handle further away then I think it'll be good. Sure moves a lot of air ------------- "Farming is a business that makes a Las Vegas craps table look like a regular paycheck" Ronald Reagan |