b-110 beavel gear pulley bearing strip
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Garden Tractors
Forum Description: A great place to discuss the Simplicity and Allis Chalmers Garden Models
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=182791
Printed Date: 23 Nov 2024 at 7:29pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: b-110 beavel gear pulley bearing strip
Posted By: bgolat
Subject: b-110 beavel gear pulley bearing strip
Date Posted: 24 Aug 2021 at 10:42pm
| I just replaced the beavel gears in my b-110 (ouch 300.00 plus bearings and seals) it runs smooth now but when I engage the clutch it has a quiet grinding sound coming from the bevel gear area? I checked the bevel gear play and there is no or very very little play, and yes i filled it with 80w-90 gear oil. I noticed some posts about rebuilding the bevels and they talked about Bearing Strip that went on the split pulley on the right side(drive pulley) I dont have one on this tractor just bought it a month ago so im not sure if it was taken off or never had one. Does anyone know if the Allis B-110 had a bearing strip on this pulley and where it goes on the pulley? Pictures would be great, Thank You very much |
Replies:
Posted By: bgolat
Date Posted: 24 Aug 2021 at 10:43pm
| Also where to get them from? |
Posted By: acken
Date Posted: 25 Aug 2021 at 6:32am
 AY, and AZ in diagram. Only used with 2 piece pulley on gearbox that drives rearend. I have cut them out of thin plastic, like ice cream pail. |
Posted By: dee_veloper
Date Posted: 25 Aug 2021 at 2:55pm
|
Zippo Varga has a brief video on this split pulley and replacing the shim using blister pack plastic. He only shows replacing one piece but there is actually two pieces as shown in the diagram from other post. When I looked at mine it appears to be more of a nylon type plastic similar to an old metal coffee can lid. https://www.youtube.com/watch?v=XWTosNAI-Z4" rel="nofollow - https://www.youtube.com/watch?v=XWTosNAI-Z4 ------------- Don't confuse my personality with my attitude. My personality is who I am. My attitude depends on who you are. |
Posted By: NorthernChill
Date Posted: 25 Aug 2021 at 3:08pm
| Thanks guys, I found the old strip bearing(looked more like thick paper) and I put it on the proper place of the pulley, I didn’t have the other round plastic bearing so I Troyes it out, it works great nice and quiet. Thanks again, you guys are great. |