Print Page | Close Window

8070 volt light

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=17930
Printed Date: 07 Feb 2025 at 12:32am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com


Topic: 8070 volt light
Posted By: randy
Subject: 8070 volt light
Date Posted: 08 Sep 2010 at 4:32pm
i put a new alt. and the volt light still comes on even at high idle, old alt checked out bad. is there a connection or a relay some where i need to check? new batteries and good cables. i bought this tractor with a bad engine and someone else took it apart and i rebuilt the motor, so i have no history about it. thanks randy

-------------
CA WD WD45 D17 D17 Diesel 7060 8050 8070



Replies:
Posted By: Brian Jasper co. Ia
Date Posted: 08 Sep 2010 at 5:03pm
Where did you get the replacement alt? My experience in the past with places like O'Reilly and Auto Zone is you will go through 3 or 4 before you find a good one. I would have the replacement tested. Make sure that the main post on the back of it has battery voltage. If it is a Delco 10SI, there should be battery voltage at both terminals on the connector with the ign sw on.

-------------
"Any man who thinks he can be happy and prosperous by letting the government take care of him better take a closer look at the American Indian." Henry Ford


Posted By: randy
Date Posted: 09 Sep 2010 at 5:35am
new alt ,i saw it tested on the bench, and yes there is power to the one post on the alt. it is a one wire alt.

-------------
CA WD WD45 D17 D17 Diesel 7060 8050 8070


Posted By: DrAllis
Date Posted: 09 Sep 2010 at 6:32am

Verify whether the alt is charging (or not) by placing an ammeter in-between the hot connection at the alt and the feed wire. It may be charging and your dashboard could be the problem by not turning off the light.



Posted By: randy
Date Posted: 09 Sep 2010 at 8:24pm
does the light panel on the dash control the volt light? will try the amp meter tomorrow, THANKS for help!!!!!!!!!!!!

-------------
CA WD WD45 D17 D17 Diesel 7060 8050 8070


Posted By: Brian Jasper co. Ia
Date Posted: 09 Sep 2010 at 9:41pm
Put a volt meter across the batteries. Should see 13.5 to 14V if it's working. I agree with the Doc.

-------------
"Any man who thinks he can be happy and prosperous by letting the government take care of him better take a closer look at the American Indian." Henry Ford


Posted By: randy
Date Posted: 19 Sep 2010 at 7:11am
finally fixed the alt, after 3 different regulators, this one is a self exciteing that starts at a lower speed and i believe it works off the stator. anyway a delco needs a special reg to work with this tractor. thanks for all the help, also sent old neihoff to be checked out, but new delco was still cheaper than a reg alone from neihoff.

-------------
CA WD WD45 D17 D17 Diesel 7060 8050 8070



Print Page | Close Window

Forum Software by Web Wiz Forums® version 11.10 - http://www.webwizforums.com
Copyright ©2001-2017 Web Wiz Ltd. - https://www.webwiz.net