Ac D17 cyclinder head bolts-Help
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=175942
Printed Date: 25 Nov 2024 at 12:54pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Ac D17 cyclinder head bolts-Help
Posted By: gordonh
Subject: Ac D17 cyclinder head bolts-Help
Date Posted: 12 Nov 2020 at 12:46pm
| I am needing to bolt my cyclinder head back down on my D17. It been awhile since I took it off. I know there is two different size bolts that fasten it down and there is some studs. Does anyone know what bolt goes where and the bolt s tighten pattern. Thanks |
Replies:
Posted By: DrAllis
Date Posted: 12 Nov 2020 at 1:21pm
| Center bolt hole on the left side is a BOLT. The two holes in front of it and rear of it are the studs. |
Posted By: Brian G. NY
Date Posted: 12 Nov 2020 at 3:15pm
Sometimes, a set of manuals can be your best friend. 
|
Posted By: DrAllis
Date Posted: 12 Nov 2020 at 3:42pm
| Numbers 5-6-7-8 are normally studs. |
Posted By: DiyDave
Date Posted: 12 Nov 2020 at 5:30pm
The general rule for tightening sequence is start at the center, and work your way out... ------------- Source: Babylon Bee. Sponsored by BRAWNDO, its got what you need! |
Posted By: Brian G. NY
Date Posted: 12 Nov 2020 at 7:42pm
Pretty much what the A-C manual shows.
|
DiyDave wrote: