Farm Equipment - Bushings for WD hand clutch

Print Page | Close Window

Bushings for WD hand clutch

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=17412
Printed Date: 05 Feb 2025 at 11:16pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Bushings for WD hand clutch

Posted By: hardwood61
Subject: Bushings for WD hand clutch
Date Posted: 30 Aug 2010 at 9:21am

Anybody have any idea of the size bushings that are used - don't have tractor close by and would like to take them along this weekend. The clutch handle wobbles severely from side to side so I am guessing that the bushings are missing or wore out. Even if you don't know the original bushing size can any one tell me the size of the pivot shaft - that way I can buy several different sizes with the correct ID and return what doesn't work.
Thanks!

Replies:

Posted By: Jeff Z. NY
Date Posted: 30 Aug 2010 at 9:59am

I think some of the early ones did not use the bushing.
Some of the early 1950's didn't use them I think.
AGCO can get them but they are not cheap.
I think around $30.00 each.
I'm not at the farm today so I can't get you the size. Sorry.

Posted By: daveingreenbay
Date Posted: 30 Aug 2010 at 10:01am

Pin diameter is .870. Hand clutch bore is 1 inch. Bushings were used on tractors with serial no.`s 34450 and up. Allis part no. for the pin is 223130. Bushing part no. is 224705. Two were used. On the last two tractors I repaired the hand clutch levers. I ended up pulling the transmission cover, driving the pin out and replacing it with a new one. The bore in the hand clutch lever was egg shaped and required boring and a custom bushing was fitted. Good Luck. HTH