Woods L59 Mower
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=173537
Printed Date: 16 Nov 2024 at 4:15pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Woods L59 Mower
Posted By: JCSinPITTS,PA
Subject: Woods L59 Mower
Date Posted: 14 Aug 2020 at 10:49am
|
Bought a used WOODS L59 mower to install on AC - B witrh manual lift and it appears the lift arm AFTER the pivot is all twisted! the upright part with the hand trigger is ok but after the bend is bad. 1. was this a 90 degree angle or something different?
|
Replies:
Posted By: HoughMade
Date Posted: 14 Aug 2020 at 11:00am
Hope this helps: ------------- 1951 B |
Posted By: ac fleet
Date Posted: 15 Aug 2020 at 12:30pm
|
Thats exactly like the thing on my B!!! ---mine is down in the shed--guess I could try a pic. of it. ------------- http://machinebuildersnetwork.com/ |
Posted By: LouSWPA
Date Posted: 15 Aug 2020 at 2:05pm
|
Jeff, If you are interested, I think I still have the hydraulic pump, and the hydraulics to convert that to a hyd lift ------------- I am still confident of this; I will see the goodness of the Lord in the land of the living. Wait for the Lord; be strong and take heart and wait for the Lord. Ps 27 |
Posted By: JCSinPITTS,PA
Date Posted: 18 Aug 2020 at 11:05am
|
Next question - the bolt the hitch mounts to is larger than the unused hole in the front (sitting on tractor) the PDF I downloaded says to use the matching holes for idler bracket. So do I use the large hole in the back of the bracket and the small holes in the front? that means the idler bracket will not be level. Does it matter? also WOODS doesn't sell the white paint in quarts only spray so dealer says to use IHC white/crème. my Allis crème is way too white.
|
Posted By: Dick L
Date Posted: 18 Aug 2020 at 11:21am
Most likely the original hole in the final drive was stripped out and re taped to a larger hole. the 1/2" bolts get loose causing the threads to be damaged then taped out for 5/8 bolts. |