Farm Equipment - Gleaner e

Print Page | Close Window

Gleaner e

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=172136
Printed Date: 18 Sep 2025 at 6:36pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Gleaner e

Posted By: Steve g
Subject: Gleaner e
Date Posted: 18 Jun 2020 at 7:15pm

Just picked up a E with a 2 row head.
I see 4 pins that what I believe hold the head on . Large drive belt is off. Am I missing anything else to take head off combine. I see a chain on a sprocket left side next to drive belt does that chain have to come off also.

Replies:

Posted By: Calvin Schmidt
Date Posted: 18 Jun 2020 at 8:25pm

The four pins are spring loaded. Push (hammer) them in and move into the slot to hold them in.

Took two grain heads off last week.

-------------
Nothing is impossible if it is properly financed

Posted By: MACK
Date Posted: 18 Jun 2020 at 8:49pm

Release two bottom pins, let head down until theirs 2 inch gap at bottom. Set jacks or blocks on each side. Release top pins and back up. MACK

Posted By: im4racin
Date Posted: 18 Jun 2020 at 9:04pm

Yes that chain has to come off. The tool on clean grain elevator has a dimple in the end to push the 4 wedge pins in. When you get them pushed in slide down in the slot to hold them in the released position. What is the serial number of your E?

Posted By: Steve g
Date Posted: 19 Jun 2020 at 8:43pm

Thanks for the replies not sure of serial number yet been sitting long time at this old boys farm. Got to get it hauled home. Jacked it up out of the ground last week only 1 flat rear tire

Posted By: ac fleet
Date Posted: 20 Jun 2020 at 3:31pm

I have an E with both heads---also got a book with it for an E III but looks like same machine almost.

-------------
http://machinebuildersnetwork.com/

Posted By: DanD
Date Posted: 20 Jun 2020 at 6:13pm

E III is same as a K except for the engine.

Posted By: im4racin
Date Posted: 20 Jun 2020 at 10:37pm

My late E(E19600) is closer to an E3 than an early E.

Posted By: Steve g
Date Posted: 27 Jun 2020 at 7:39pm

Pulled top radiator hose very green antifreeze in stat housing and drain plug in radiator came out and again very green water shot out . Will it start

Posted By: im4racin
Date Posted: 27 Jun 2020 at 9:42pm

Hard to say. One of mine was stored inside all but the last 3 years before I got it. It had stuck valves. Bought an f that was in the pasture for 25 and it started and drove off trailer.

Going to help a friend get a 6600 gas that has been in the weeds for 10 years tomorrow. Hope for the best as he wants to take it to the field this fall!