Farm Equipment - D10 - D12 parts wanted

Print Page | Close Window

D10 - D12 parts wanted

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=16642
Printed Date: 05 Feb 2025 at 3:50am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: D10 - D12 parts wanted

Posted By: Tracy Martin TN
Subject: D10 - D12 parts wanted
Date Posted: 15 Aug 2010 at 10:09pm

Looking for the hyd pump intake hose for series II or III. Are the rubber dampners available for the PTO? Thanks Tracy Martin

Replies:

Posted By: Dusty MI
Date Posted: 16 Aug 2010 at 8:41am

Tracy, my local AGCO dealer did a nation wide check for the intake hose for my D-10 seres III, there were none available.

I went to a local NAPA dealer they could get a hose that was similar. My hose had a large split in it. I got a piece of shrink tubing for electrical joints. I also used some Scotch Coat which is a liquid used for water proofing electrical joints. I coated my split hose with the Scotch Coat then put the shrink on and shrink it then applied another coat of Scotch Coat.

It's the same story on the dampers.

I have 1 in like new condition. I WILL NOT PART WITH IT.

I made some out of neoprene. I can make some more.

Dusty

-------------
917 H, '48 G, '65 D-10 series III "Allis Express"

Posted By: Tracy Martin TN
Date Posted: 16 Aug 2010 at 8:53am

Dusty, Thanks for your info. I sent you a PM also. Tracy Martin

Posted By: Bob in King NC
Date Posted: 16 Aug 2010 at 9:22am

Tracy. if its the hose I'm thinking of. I go to local hyd dealer and get a piece of hyd hose and cut to correct length ,3/4 the best I remember and they sell spring that goes inside to keep from kinking. I have replaced 2 like this and have had no trouble over the past 7 or 8 years. My 2 cents, Bobby in King, NC.