200 hard getting into reverse
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=166250
Printed Date: 25 Aug 2025 at 11:27am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 200 hard getting into reverse
Posted By: Lonn
Subject: 200 hard getting into reverse
Date Posted: 30 Nov 2019 at 7:18pm
It acts like the stubby shift lever back under the cover where you check trans and hyd oil doesn't move far enough to the right to easily slide into reverse. When shifting I have to nudge that little lever to the right with my foot then it shifts easily. I've owned this tractor for 2 or 3 years and it's been like that since I bought it.
If I remove the long cover over the shift linkage, that allows the long shift lever more travel and then it shifts without problem. Was thinking tonight maybe it's dry in the socket?
I could video this if needed.
-------------
-- --- .... .- -- -- .- -.. / .-- .- ... / .- / -- ..- .-. -.. . .-. .. -. --. / -.-. .... .. .-.. -.. / .-. .- .--. .. ... -
Wink
I am a Russian Bot
|
Replies:
Posted By: bradley6874
Date Posted: 30 Nov 2019 at 7:54pm
With the cover off rock the shifter left to right and back watch the joints you’ll figure out where the slack is , my bolts were wore all I needed was new bolts
-------------
You can wash the dirt off the body but you can’t wash the farmer out of the heart and soul
|
Posted By: DrAllis
Date Posted: 30 Nov 2019 at 8:17pm
|
Tighten each of the yoke bolts until they are too tight and then back them off until it shifts easy. Oil each joint too.
|
Posted By: DougG
Date Posted: 01 Dec 2019 at 11:11am
|
Like was said , linkage adjusments and worn bolts usually is the problems,, the socket ball assembly is available thru Mc master carr ,,
|
|